The faucet is in. According to everything I read, swapping out a faucet is one of the easiest DIY projects you can take on. I'm sure that's true ... if you read the instructions and make sure you have everything you need.
First snag: I didn't have a basin wrench. "Who needs one of those?" I asked myself. Me, apparently. There were these little nuts (see left) up behind the basin (what else) that connected the old faucet to the sink. So it was off to Home Depot at 9 last night. Got home at 10 and removed those nuts with no problem.
That's when I realized that when you replace a single-control faucet with a dual-control one, you need hoses to connect the faucet controls to the water supply. Home Depot was closed by then, so secured the faucet in place, then gave up and went to bed.
Off to the Depot again this morning, returning triumphantly with flexible water supply hoses and plumbing joint compound. I attached one end of the hose to the bottom of the faucet. That's when I hit snag #2: They were too short. By about six inches.
Back to HD(trip #3 if you're counting). I returned the 12-inch hoses, picked up some 20-inchers and headed home. Ten minutes later, we had running water. Success!
Lessons learned:
1. Read the directions (see below - notice the handy drawings of both a basin wrench and flexibe water supply line)
2. Make sure you have the right tools and supplies - BEFORE removing the old faucet.
3. Measure, measure, measure
4. Expect at least one flesh wound. Or battle scar, if you prefer. (See below. I have a matching one on my right hand)
5. Save the Guinness until AFTER you're done.
No comments:
Post a Comment